Effect of laser welding on the titanium ceramic tensile bond strength

Titanium reacts strongly with elements,mainly oxygen at high temperature. the high temperature of titanium laser welding modifies the surface,and may interfere on the metal-ceramic tensile bond strength. objective: the influence of laser welding on the titanium-ceramic bonding has not yet been established. the purpose of this in vitro study was to analyze the influence of laser welding applied to commercially pure titanium (cpti) substructure on the bond strength of commercial ceramic. the influence of airborne particle abrasion (al2o3) conditions was also studied. material and methods: forty cpti cylindrical rods (3 mm × 60 mm) were cast and divided into 2 groups: with laser welding (l) and without laser welding (wl). each group was divided in 4 subgroups,according to the size of the particles used in airborne particle abrasion: a-al2o3 (250 μm); b-al2o3 (180 μm); c-al2o3 (110 μm); d-al2o3 (50 μm). ceramic rings were fused around the cpti rods. specimens were invested and their tensile strength was measured at fracture with a universal testing machine at a crosshead speed of 2.0 mm/min and 200 kgf load cell. statistical analysis was carried out with analysis of variance and compared using the independent t test (p≤0.05). results: significant differences were found among all subgroups (p<0.05). the highest and the lowest bond strength means were recorded in subgroups wlc (52.62 mpa) and ld (24.02 mpa),respectively. conclusion: airborne particle abrasion yielded significantly lower bond strength as the al2o3 particle size decreased. mechanical retention decreased in the laser-welded specimens,i.e. the metal-ceramic tensile bond strength was lower.