analyzing friction bolts load bearing capacity in varying rock masses: an experimental study in anti atlas imiter silver mining region, morocco

This study analyzes how key factors impact friction rock bolt capacity using standard pull-out tests, focusing on 39 mm diameter, 180 cm long split-tube bolts. we investigate bolt performance dependence on rock mass rating (rmr), time after installation, schistosity orientation, surface roughness, and installation quality. the aim is optimizing bolt design and implementation for enhanced underground stability and safety. results show rmr strongly exponentially correlates with pull-out resistance; higher quality rock masses increase capacity. anchorage capacity significantly rises over time, especially for rmr above 70. increasing angle between bolt axis and rock foliation from 0 to 90° boosts pull-out response. reducing borehole diameter below bolt diameter grows bolt-ground friction. empirical models estimate load capacity based on rmr, time, orientation, diameter, roughness and installation quality. these reliably predict bolt performance from site conditions, significantly improving on basic rmr methods. experiments provide practical friction bolt behavior insights for typical rock masses. the data-driven analysis ensures models are applicable to actual underground scenarios. this enables tailored optimization of bolting configurations and supports. methodologies presented should improve safety, efficiency and cost-effectiveness of reinforced mining and tunneling. overall, this study fundamentally furthers friction bolt performance understanding, enabling superior underground support design.