A two-phase, non-isothermal model for water management in the cathode gas diffusion layer of polymer electrolyte membrane fuel cells

Water management is essential because of its effect on the performance and durability of polymer electrolyte membrane (pem) fuel cells. this paper uses a non-isothermal two-phase model to study the flow in the cathode gas diffusion layer (gdl) of a pem fuel cell. for this purpose, the conservation equations of mass, momentum, energy, and other auxiliary equations have been solved numerically and validated with data available from papers with an error of less than 2%. the results show that the pressure variation of the gas mixture (pg) along the cathode gdl is negligible, while the capillary pressure (pc) is significant. an increase in the pressure of the cathode channel as well as the porosity of gdl leads to an increase in the concentration of oxygen in the cathode catalyst layer, but by increasing the porosity coefficient of the electrodes from 0.4 to 0.7, the effective thermal conductivity of the fuel cell decreases and the maximum temperature of the fuel cell increases by about 1k. the flow of liquid water and the consequent saturation are higher in the vicinity of the cathode catalyst layer, but due to evaporation, their amount decreases as the channel approaches. in the current density range of 0.6< j< 1a/cm2, the α parameter (which is defined as the ratio of the water entering from the membrane to the catalyst to the water produced due to the reaction) tends to a constant value of 1.2.