Humic Acid Removal From Aqueous Solutions By Peroxi-Electrocoagulation Process

Background: natural organic matter is the cause of many problems associated with water treatment such as the presence of disinfection byproducts (dbps) and membrane fouling during water filtration. in this study, the performance of the peroxielectrocoagulation process (pep) was investigated for the removal of humic acids (has) from aqueous solutions. methods: pep was carried out for the removal of ha using a plexiglas reactor with a volume of 2 l and fitted with iron electrodes and a direct current supply (dc). sles were taken at various amounts of ph (24), current density (1 and 2a/cm2), hydrogen peroxide (50150 mg/l) and reaction time (520 minutes) and then filtered to remove sludge formed during reaction. finally, the ha concentration was measured by uv absorbance at 254 nm (uv254). results: results indicated that increasing the concentration of h2o2 from 50 to 150 mg/l increased ha removal efficiency from 83% to 94.5%. the highest removal efficiency was observed at ph 3.0 by increasing the ph to the alkaline range, the efficiency of the process was reduced. it was found that ha removal efficiency was high in current density 1a/cm2. increasing current density up to 1 a cm2 caused a decrease in removal efficiency. results of this study showed that under the optimum operating range for the process ([current density] = 1a/cm2, [hydrogen peroxide concentration] = 150 mg/l, [reaction time]= 20 minutes and [ph]= 3.0), ha removal efficiency reached 98%. conclusion: it can be concluded that pep has the potential to be utilized for costeffective removal of ha from aqueous solutions.