Rotor Speed Control of a Direct-Driven Permanent Magnet Synchronous Generator-Based Wind Turbine Using Phase-Lag Compensators to Optimize Wind Power Extraction

Due to the intermittent nature of wind,the wind power output tends to be inconsistent,and hence maximum power point tracking (mppt) is usually employed to optimize the power extracted from the wind resource at a wide range of wind speeds. this paper deals with the rotor speed control of a 2 mw direct-driven permanent magnet synchronous generator (pmsg) to achieve mppt. the proportional-integral (pi),proportional-derivative (pd),and proportional-integral-derivative (pid) controllers have widely been employed in mppt studies owing to their simple structure and simple design procedure. however,there are a number of shortcomings associated with these controllers; the trial-and-error design procedure used to determine the p,i,and d gains presents a possibility for poorly tuned controller gains,which reduces the accuracy and the dynamic performance of the entire control system. moreover,these controllers' linear nature,constricted operating range,and their sensitivity to changes in machine parameters make them ineffective when applied to nonlinear and uncertain systems. on the other hand,phase-lag compensators are associated with a design procedure that is well defined from fundamental principles as opposed to the aforementioned trial-and-error design procedure. this makes the latter controller type more accurate,although it is not well developed yet,and hence it is the focus of this paper. the simulation results demonstrated the effectiveness of the proposed mppt controller. © 2017 ester hamatwi et al.