Separation of Oily Pollution From Water and Wastewater By Low Cost and Reusable Composite Based on Natural Fibers

Adsorption of pollution with porous media is a low cost and effective method for wastewater treatment. in this study, the activated carbon powder treated on the natural cotton fibers by a solvo-thermal method. acetone and hydrazine were used as solvents. the porous, low cost and hydrocarbon loving adsorbents were obtained. ultrasonic waves applied for homogeneous distribution of powder. adsorbent characterization performed by ftir and sem analysis. batch adsorption experiments carried out to remove the spill of motor engine oil on the water. adsorption, desorption and reuse of the adsorbent were done in 5 steps. the highest adsorption capacity was 40.2 g/g. after 5 replicate of adsorbent reuse, the adsorption efficiency and recovery percentage were about 90%. continuous experiments performed by 500 ml of two petrochemical and refinery wastewater samples with 2 g of adsorbent at two different flow rates. the results showed that removal percentage of oil achieved to 96%, in the inlet concentration less than 40 g oil per each gram of adsorbent. by increasing the amount of inlet oil above 40 g/g, the adsorption efficiency decreased. for these wastewaters, by increasing the amount of adsorbent from 2g to 3 g, the oil pollution was completely absorbed. therefore, this composite with acceptable performance can be used for spill remove and continuous removal of oil pollutions from water and wastewater.