|
|
طراحی و ساخت فیلتر مینیاتوری باند وسیع مایکروویو با استفاده از حلقه ریزنواری مستطیلی بارگذاریشده با استابهای مدارباز
|
|
|
|
|
نویسنده
|
دانائیان مصطفی
|
منبع
|
الكترومغناطيس كاربردي - 1399 - دوره : 8 - شماره : 2 - صفحه:9 -15
|
چکیده
|
در این مقاله، یک فیلتر جدید باند وسیع بسیار کوچک با استفاده از حلقه مستطیلی بارگذاری شده با دو استاب مدارباز ارائه شده است. در این طراحی بهمنظور رسیدن به پاسخ فرکانسی یک فیلتر میانگذر دارای باند عبور وسیع، یک حلقه ریزنواری مستطیلشکل که در میان دو خط انتقال فاصلهدار دوتایی دارای تزویج موازی قرار گرفته، استفاده شده است. با استفاده از این پیکرهبندی، چهار قطب انتقال تولید میشود که بهمنظور کنترل قطبهای انتقال در باند عبور، از دو استاب مدارباز استفاده شده است. بهمنظور کاهش ابعاد فیلتر طراحی شده، دو استاب مدارباز در داخل حلقه مستطیلشکل تعبیه شدهاند. برای اعتبار بخشی به روش طراحی، ساختار فیلتر پیشنهادی ساخته و اندازهگیری شده است. با توجه به نتایج بهدستآمده بهوضوح دیده میشود که نتایج اندازهگیری با نتایج شبیهسازی سازگاری خیلی خوبی دارند. فیلتر پیشنهادی دارای پهنای باندی است که محدوده ghz 3.2 تا ghz 10.6 را پوشش میدهد که این محدوده فرکانسی معادل پهنای باند کسری % 107.5 است. فیلتر طراحیشده دارای لبههای تیز، تلفات باند عبور بسیار کم و مهمتر از همه، ابعاد کوچک است.
|
کلیدواژه
|
فیلتر میانگذر باند وسیع، حلقه مستطیلشکل ریزنواری، خطوط فاصلهدار دوتایی با تزویج موازی، استاب مدارباز، ابعاد کوچک
|
آدرس
|
دانشگاه ولی عصر رفسنجان, گروه مهندسی برق, ایران
|
پست الکترونیکی
|
danaeian@vru.ac.ir
|
|
|
|
|
|
|
|
|
Design and Fabrication of the Miniaturized UltraWide Band Pass Filter Using the Microstrip Rectangular Ring Loaded by Open Stubs
|
|
|
Authors
|
Danaeian Mostafa
|
Abstract
|
In this article a miniaturized ultrawideband (UWB) bandpass filter (BPF) using the microstrip rectangular ring loaded by two open stubs is presented. The proposed structure consists of two doublet parallel coupling gaps at each side of a microstrip ring. In comparison with some other filters, this structure shows a significantly wider passband due to the introduction of a crosscoupling between the feed lines (input and output) which generates four pairs of transmission poles in the passband. In order to control the transmission poles in the pass band and adjust the transmission poles near the lower and upper edges of the filter, two open stubs have been loaded on the microstrip rectangular ring. Consequently, a compact four poles ultrawide bandpass filter is designed which exhibits extremely sharp rejection skirts around the target passband. The proposed filter has a passband that covers 3.2 to 10.6 GHz and its measured 3 dB fractional bandwidth is about 107.5%. In order to validate the performance of the proposed technique, the designed UWB bandpass filter is fabricated and experimental verification is provided. A good agreement has been found between the results obtained by simulation and the measurements. Furthermore, rejection level better than 20 dB in upper stopband is extended to around 15 GHz. To our knowledge, the size of the proposed ultrawideband filter is more compact in comparison with known similar filters.
|
Keywords
|
|
|
|
|
|
|
|
|
|
|
|