different references for valgus cut angle in total knee arthroplasty

Background: the valgus cut angle (vca) of the distal femur in total knee arthroplasty (tka) is measured preoperativelyon three-joint alignment radiographs. the anatomical axis of the femur can be described as the anatomical axis of thefull length of the femur or as the anatomical axis of the distal half of the femur, which may result in different anglesin some cases. during tka, the anatomical axis of the femur is determined by intramedullary femoral guides, whichmay follow the distal half or near full anatomical axis, based on the length of the femoral guide. the aim of this studywas to compare using the anatomical axis of the full length of the femur versus the anatomical axis of the distal half ofthe femur for measuring vca, in normal and varus aligned femurs. we hypothesized that the vca would be differentbased upon these two definitions of the anatomical axis of the femur.methods: full-length weight bearing radiographs were used to determine three-joint alignment in normal aligned(lateral distal femoral angle; ldfa = 87º ± 2º) and varus aligned (ldfa >89º) femurs. full-length anatomical axismechanicalaxis angle (angle 1) and distal half anatomical axis-mechanical axis angle (angle 2) were measured inall subjects by two independent orthopedic surgeons using a dicom viewer software (pacs). angles 1 and 2 werecompared in normal and varus aligned subjects to determine whether there was a significant difference.results: ninety-seven consecutive subjects with normally aligned femurs and 97 consecutive subjects with varusaligned femurs were included in this study. in normally aligned femurs, the mean value of angle 1 was 5.05° ± 0.76°and for angle 2 was 3.62° ± 1.19°, which were statistically different (p= 0.0001). in varus aligned femurs, the meanvalue of angle 1 was 5.42° ± 0.85° and for angle 2 was 4.23° ± 1.27°, which were also statistically different (p=0.0047).conclusion: the two different methods of outlining the anatomical axis of the femur lead to different results inboth normal and varus-aligned femurs. this should be considered in determination of the valgus cut angle on preoperativeradiographs and be adjusted according to the length of the intramedullary guide.