Effect of air injection under subsurface drip irrigation on yield and water use efficiency of corn in a sandy clay loam soil

Subsurface drip irrigation (sdi) can substantially reduce the amount of irrigation water needed for corn production. however, corn yields need to be improved to offset the initial cost of drip installation. air-injection is at least potentially applicable to the (sdi) system. however, the vertical stream of emitted air moving above the emitter outlet directly toward the surface creates a chimney effect, which should be avoided, and to ensure that there are adequate oxygen for root respiration. a field study was conducted in 2010 and 2011, to evaluate the effect of air-injection into the irrigation stream in sdi on the performance of corn. experimental treatments were drip irrigation (di), sdi, and sdi with air injection. the leaf area per plant with air injected was 1.477 and 1.0045 times greater in the aerated treatment than in di and sdi, respectively. grain filling was faster, and terminated earlier under air-injected drip system, than in di. root distribution, stem diameter, plant height and number of grains per plant were noticed to be higher under air injection than di and sdi. air injection had the highest water use efficiency (wue) and irrigation water use efficiency (iwue) in both growing seasons; with values of 1.442 and 1.096 in 2010 and 1.463 and 1.112 in 2011 for wue and iwue respectively. in comparison with di and sdi, the air injection treatment achieved a significantly higher productivity through the two seasons. yield increases due to air injection were 37.78% and 12.27% greater in 2010 and 38.46% and 12.5% in 2011 compared to the di and sdi treatments, respectively. data from this study indicate that corn yield can be improved under sdi if the drip water is aerated.