>
Fa   |   Ar   |   En
   بررسی تاثیر استغراق ‌های مختلف بر پارامترهای هیدرولیکی جریان در دریچه سالونی مستطیلی چند گانه  
   
نویسنده فتحی ستاره ,سجادی محسن ,احدیان جواد ,پارسائی عباس
منبع مديريت آب و آبياري - 1403 - دوره : 14 - شماره : 2 - صفحه:249 -261
چکیده    یکی از راه‌ کارهای پیشنهادی در خصوص افزایش کیفیت توزیع و انتقال آب استفاده از دریچه‌های سالونی است .در این پژوهش از دریچه‌ی سالونی چندگانه مستطیلی استفاده‌شده است و با شبیه‌سازی عددی پارامترهای هیدرولیکی جریان بررسی و باحالت تک دریچه مقایسه شده است. شبیه‌سازی‌ها در سه دبی 25، 35و 45 لیتر بر ثانیه و سه بازشدگی 35، 40 و 45 درجه و سه استغراق 70، 80 و 90 درصد در نرم‌افزار flow3d و با مدل آشفتگی rng انجام‌شده است. با بررسی منحنی دبی اشل مشاهده می‌شود که ضریب آبگذری در تمام استغراق‌ها در حالت دو دریچه از حالت تک دریچه بیشتر است .بررسی بیشینه‌ی سرعت نتایج نشان داد که این پارامتر با میزان استغراق رابطه‌ی عکس دارد به‌گونه‌ای که با افزایش استغراق، بیشینه سرعت کاهش پیدا می‌کند که این میزان کاهش در حالت دو دریچه 7/87 درصد نسبت به حالت تک دریچه هست. در بررسی بیشینه‌ی انرژی متلاطم نتایج نشان داد که انرژی متلاطم با دبی رابطه مستقیم داشته و با میزان استغراق رابطه‌ی معکوس دارد به‌طوری‌که با افزایش استغراق، انرژی متلاطم کاهش پیدا می‌کند که این میزان کاهش در حالت دو دریچه 13درصد نسبت به حالت تک دریچه خواهد بود. با بررسی کیفی گردابه‌های جریان نیز نتایج نشان داد که گردابه‌ها در حالت تک دریچه قدرت و کشیدگی بیشتری نسبت به حالت دو دریچه دارند. همچنین با بررسی نتایج مشخص شد که با افزایش درصد استغراق، کشیدگی و قدرت گردابه‌ها کاهش می‌یابد.
کلیدواژه بیشینه سرعت، بیشینه انرژی متلاطم، گردابه، flow3d
آدرس دانشگاه شهید چمران اهواز, دانشکده مهندسی آب و محیط زیست, گروه سازه های آبی, ایران, دانشگاه شهید چمران اهواز, دانشکده مهندسی آب و محیط زیست, گروه سازه های آبی, ایران, دانشگاه شهید چمران اهواز, دانشکده مهندسی آب و محیط زیست, گروه سازه های آبی, ایران, دانشگاه شهید چمران اهواز, دانشکده مهندسی آب و محیط زیست, گروه سازه های آبی, ایران
پست الکترونیکی parsaie@scu.ac.ir
 
   investigation of the effect of different submerging on the flow hydraulic parameters in multiple rectangular lopac gates  
   
Authors fathi setareh ,sajjadi mohsen ,ahadiyan javad ,parsaie abbas
Abstract    one of the suggested ways to increase the quality of water distribution and transfer is to use lopac gates. in this research, rectangular multiple lopac gates have been used and the hydraulic parameters of the current have been investigated by numerical simulation and compared with the single gate state. the simulations have been performed in three discharges of 25, 35, and 45 liters per second and three openings of 35, 40, and 45 degrees, and three submerging of 70, 80, and 90% in flow3d software and with the rng turbulence model. by examining the stage-discharge curve, it can be seen that the permeability coefficient is higher in all absorptions in the two-gate state than in the single-gate state. investigating the maximum speed of the results showed that this parameter has the opposite relationship with the amount of submerging, as the submerging increases, the maximum speed decreases, which is an 7.87% reduction in the two-gate state compared to the single-gate state. in the investigation of the maximum turbulent energy, the results showed that the turbulent energy has a direct relationship with the discharge and has an inverse relationship with the submerging rate,  so, with the increase of submerging, the turbulent energy decreases, which will be 13% in the two-gate state compared to the single-gate state. by qualitatively investigating the flow vortices, the results showed that the vortices in the single-gate state have more strength and elongation than the two-gate state. also, by investigating the results, it was found that the elongation and vortices strength decrease with the increase in submerging percentage.
Keywords flow3d ,maximum speed ,maximum turbulent energy ,vortex
 
 

Copyright 2023
Islamic World Science Citation Center
All Rights Reserved