|
|
بررسی ضخامت فیلتر شنی بر تصفیه آب در آبیاری قطره ای
|
|
|
|
|
نویسنده
|
رجا امید ,میرزایی فرهاد ,شهریاری اسماعیل
|
منبع
|
مديريت آب و آبياري - 1400 - دوره : 11 - شماره : 1 - صفحه:73 -86
|
چکیده
|
استفاده از سامانههای آبیاری قطرهای در کشاورزی با مزایای متعددی همراه است، انسداد فیلترها و قطرهچکانها و در نتیجه کاهش یکنواختی پخش آب مسئلهای است که طرح و ساخت مناسب فیلتر میتواند یکی از این راهکارهای حل مناسب آن مسئله باشد. در این مطالعه از یک مدل فیزیکی شامل یک مخزن فیلتر به ارتفاع یک متر و قطر 60 سانتیمتر جهت جایگذاری شن و ماسه با دانهبندی مختلف و ضخامت لایه متفاوت بههمراه یک پمپ با توان 0.5 اسب بخار بهمنظور تامین فشار، دو عدد فشارسنج برای تعیین افت بار هیدرولیکی در فیلتر شنی، آب خام با کیفیت مشخص استفاده شد. از 9 تیمار دانهبندی و لایهبندی و دو تیمار کیفیت آب حاوی مقادیر مواد معلق در آن استفاده شد. دانه بندی این تیمارها به ترتیب 1.77، 0.89 و 0.45 میلیمتر بود. نتایج نشان داد تغییرات افت بار در بازه دانه بندی 1.77– 0.89 کمتر از بازه ی 0.89– 0.45 است و با ریزتر شدن اندازه ذرات شن افت بار افزایش یافت. نتایج نشان داد تغییرات درصد تصفیه در بازه ی دانه بندی 1.77– 0.89 کمتر از بازه ی 0.89– 0.45 می باشد و با افزایش ارتفاع لایه وسط درصد تصفیه فیلترها افزایش یافت. اما تغییرات درصد تصفیه به ازای تغییر ارتفاع از 12 تا 17 سانتیمتر بیشتر از تغییرات درصد تصفیه از 17 تا 22 سانتیمتر بود. ذرات رس، بقایای گیاهی، حشرات جزء مواد معلق در آب میباشند که بایستی برای آبیاری قطرهای توسط فیلترها تصفیه شوند.
|
کلیدواژه
|
آبیاری قطره ای، تصفیه آب، ضخامت، لایه شن فیلتر
|
آدرس
|
دانشگاه تهران، پردیس کشاورزی و منابع طبیعی, گروه مهندسی آبیاری و آبادانی, ایران, دانشگاه تهران، پردیس کشاورزی و منابع طبیعی, گروه مهندسی آبیاری و آبادانی, ایران, دانشگاه تهران، پردیس کشاورزی و منابع طبیعی, گروه مهندسی آبیاری و آبادانی, ایران
|
|
|
|
|
|
|
|
|
|
|
Investigation of Sand Filter Thickness on Water Treatment in Drip Irrigation
|
|
|
Authors
|
Raja Omid ,Mirzaei Farhad ,Shahriyari Esmail
|
Abstract
|
The use of drip irrigation systems in agriculture is associated with several problems. Clogging of filters and drippers and, thus reducing the uniformity of water distribution needs to be addressed. Proper design and construction of the filter can be one of these suitable solutions to the problem. In this study, a physical model including a filter tank with a height of one meter and a diameter of 60 cm for placing sand with different sand size and thickness of different layers along with a pump, a power of 0.5 horsepower to provide pressure, two pressure gauges were used to determine the hydraulic load losses in the sand filter and, raw water of specified quality. 9 treatments of granulation and layering and, two treatments of water quality containing the amount of suspended solids were used. The aggregation of these treatments was 1.77, 0.89, and 0.45 mm, respectively. The results showed that the load loss changes in the granulation range of 0.89 – 1.77 mm is less than the range of 0.45–0.89 mm. the load loss increased with the smaller particle size of sand. The results showed that the percentage change of filtration in the granulation range of 1.77 0.89 is less than the range of 0.45 0.89 mm and with increasing the height of the middle layer, the percentage of filtration of filters increased. The results showed that the percentage change of filtration in the granulation range of 0.89 – 1.77 mm is less than the range of 0.45 0.89 mm. The percentage of filtration increased with increasing the height of the middle layer. But, the changes in the percentage of filtration for changing the height from 12 to 17 cm were more than the changes in the percentage of filtration from 17 to 22 cm. Clay particles, plant debris, insects are watersoluble substances that must be refined by filters for drip irrigation.
|
Keywords
|
|
|
|
|
|
|
|
|
|
|
|