interfacial phases and defects characteristics of al/cu-zn bimetal produced via centrifugal casting process

Centrifugal casting process, in both horizontal and vertical mode, is considered as an efficient method to produce bimetallic components. al/cu65zn35 couples were prepared by the vertical centrifugal casting process. in this study, different volume of molten aluminum having melttosolid (m/s) volume ratios (vr) of 1.5 and 2.5, were cast into preheated brass bush rotating at 800, 1600, and 2000 (rpm), respectively. the thickness of the interface, which is composed of three different zones, is depended on the rotational speed and the (vr) and was at least 490 micro;m (at vr=1.5 and 2000 rpm) and at most 1480 micro;m (at vr=2.5 and 800 rpm). the results of optical microscopy, energy dispersive xray spectroscopy (eds), and xray diffraction analysis showed that the interface layers are composed of al2cu5zn4, al3cu3zn, al2cu precipitates dispersed in the matrix and finally alpha;al/al2cu anomalous eutectic structure near the aluminum side. gas pore entrapment and oxide film entrainment defect was detected within the interface next to the aluminum base metal.