>
Fa
|
Ar
|
En
international journal of advanced design and manufacturing technology
سال:2016 - دوره:9 - شماره:4
A New Method for Measuring Perforated Surface by Coordinate Measuring Machine (CMM)
- صفحه:89-97
Accuracy Improvement of Upper Bound Analysis of Bimetallic Rods Extrusion Using a New Velocity Field
- صفحه:99-107
An Experimental Investigation of the Effects of Fiber Laser Percussion Drilling: Influence of Process Parameters
- صفحه:7-12
An Intelligent Knowledge Based System for CO2 Laser Beam Machining for Optimization of Design and Manufacturing
- صفحه:39-50
Analysis of Off-road Performance for a Tracked Vehicle
- صفحه:109-119
Effect of AFM Cantilever Geometry on the DPL Nanomachining process
- صفحه:75-80
Influence of Vibratory Finishing Process by Incorporating Abrasive Ceramics and Glassy Materials on Surface Roughness of CK45 Steel
- صفحه:1-6
Investigations on Surface Integrity and Electrochemical Behavior of Machined Co-Cr-Mo Bio-implant Alloy
- صفحه:51-58
Mechanical Properties and Microstructural Evolution of AA5083/Al_2O_3 Composites Fabricated by Warm Accumulative Roll Bonding
- صفحه:13-22
Numerical Study of Coupled Non-Gray Radiation and Separation Convection Flow in a Duct using FSK Method
- صفحه:23-38
Pareto Optimal Design of Passive and Active Vehicle Suspension Models
- صفحه:59-73
Studying Shear and Discharge Rate of Proteins in Microfluidic Junctions, under Electrokinetic Effects
- صفحه:81-87
Copyright 2023
Islamic World Science Citation Center
All Rights Reserved
