|
|
|
|
بررسی عددی انتقال حرارت در لایه های اختلاطی جریان آشفته سیال تراکم پذیر در هندسه مکعبی با استفاده از روش گردابه های بزرگ
|
|
|
|
|
|
|
|
نویسنده
|
اجاقلو اکبر ,محمد صادقی آزاد محمدباقر ,چوبداررحیم فرزاد
|
|
منبع
|
مهندسي مكانيك - 1403 - دوره : 33 - شماره : 5 - صفحه:26 -41
|
|
چکیده
|
در این مقاله تمرکز بر روی سیال تراکم پذیر می باشد که تا کنون در هندسه با ابعاد خیلی بزرگ و سرعت بالا شبیه سازی صورت نگرفته است. همچنین روش گردابه های بزرگ نسبت به روش های شبیه سازی عددی دیگر، دقت بالاتری در مدل سازی جریان آشفته دارد. هندسه مورد نظر یک مکعب است که در ابعاد 30 متر می باشد، و شبیه سازی در دو حالت مکانی و زمانی به صورت جداگانه برای 100 ثانیه انجام شده است. ورودی ها در حالت های مختلف متفاوت است؛ به این صورت که برای حالت مکانی دو ورودی هم جهت با سرعت های متفاوت، و برای حالت زمانی دو ورودی با جهت های مخالف و با سرعت های یکسان در نظر گرفته شده است. نتایج کلی که از این شبیه سازی به دست آمد، نشان داد که در حالتی که ورودی ها کنار یکدیگر هستند و گرادیان سرعت بیشتر است، شاهد آشفتگی، انرژی جنبشی و قدرت بیشتر گردابه ها و اندازه بزرگتر آنها هستیم. اما در حالت زمانی به علت اینکه ورودی ها از یکدیگر فاصله دارند، تقابل به خوبی صورت نگرفته بنابراین قدرت گردابه ها کمتر و گردابه های کوچکتر و پخش کمی نسبت به حالت مکانی مشاهده گردید.
|
|
کلیدواژه
|
جریان آشفته، شبیه سازی گردابه های بزرگ، لایه اختلاطی، انتقال حرارت، جریان تراکم پذیر، مکعب
|
|
آدرس
|
, ایران, , ایران, دانشگاه شهید مدنی آذربایجان, دانشکده مهندسی مکانیک, ایران
|
|
پست الکترونیکی
|
farzad_choobdar@yahoo.com
|
|
|
|
|
|
|
|
|
|
|
|
|
numerical investigation of heat transfer in mixing layers of turbulent flow of compressible fluid in cubic geometry using large eddy simulation
|
|
|
|
|
Authors
|
ojaghlou akbar ,mohammad sadeghi azad mohammad bagher ,choobdar rahim farzad
|
|
Abstract
|
in this article, the focus is on compressible fluid, which has not been simulated in geometry with very large dimensions and high speed. also, the method of large eddies has higher accuracy in turbulent flow modeling than other numerical simulation methods.the desired geometry is a cube with dimensions of 30 meters, and we have performed the simulation in two spatial and temporal modes separately for 100 seconds. the inputs are different in different modes so for the spatial mode, we have considered two inputs in the same direction with different speeds, and for the time mode, we have considered two inputs in opposite directions and with the same speeds. the general results obtained from this simulation showed that when the inlets are next to each other and the vortices' opposition is greater, we see more turbulence, kinetic energy and strength of the vortices and their larger size. but in the temporal mode, because the inputs are far from each other, the confrontation was not done well, so we observed less strength of eddies and smaller eddies and little spread compared to the spatial mode.
|
|
Keywords
|
turbulent flow ,large eddy simulation ,mixing layers ,heat transfer ,compressible flow ,cubic
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|